|
|
| *Vultures Knob>>>Bike Lights |
Putting a light on a dirtbike? (headlight) |
i have an old 84' kx 125, i like to ride at some later times of the day but being a standard dirtbike it has no lights, is it in anyway possible to wire up/connect a trail bike front light the way the bike is? it doesnt have a battery or altinator so could i at all run it off the engine? I would check out your ignition. I don't have a lot of experience with trail bikes, but motorcycles will have an accessory lead on the ignition. You just have to wire it to that. Then, somewhere in the negative wire, attach a switch. The negative will go to some ground on the bike. Also, you need to make sure the accessory lead has the right voltage. Most headlights will be 12V or 6V. As far as no battery or alternator, your bike has a generator. It works like an alternator. The generator will power the light. DO YOU HAVE A WORK SHOP??? |
| Tags |
| Bike Tours Trail Map Bike Pedals Bike Lock Bike Lights Bike Helmet Quad Bike Pocket Bike Mini Bike |
| Related information |
Could be a couple of reasons why she didn't mention it at the time, like maybe she thought it was accidental. However, if she offers you a ride again, this means she liked it and she'd li... yes..that is an awesome way! keep it up and good luck..dont give up ...Underneath the pavement there is an inductive-loop traffic detector. This loop detects the amount of iron inside the loop. The problem is that most motorcycles contain more aluminum alloys and fi... You are not stealing it back if you found it. How can you steal something that belongs to you? Leaving a nice note explaining the fact that it's your bike would be nice for some one who is uns... Rear fender $250 - 300 UNPAINTED, Tail light assembly $300 - 350. Then youv'e got labour and paint! Not cheap! ...You need to take the bike in and have the tech run digital tech on it because the J1850 circuit (how the ECM talks to the speedo and the TSSM) is not communicating with the TSSM or the TSSM (Turn S... ive done the same a couple of times...just swap the complite starter coil unit from your old engine into the new one..that way you dont need to change any wiring ...Sorry to crash your question my dear - but people have given you good advice already and you seem to have already taken a wise decision. However just who the f**k is this bikernoj bloke? A true san... |
Bike Categories--Copyright/IP Policy--Contact Webmaster |